Cisco 3020 - Cisco Catalyst Blade Switch Aan de slag handleiding - Pagina 16

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 31 pagina's. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Ook voor Cisco 3020 - Cisco Catalyst Blade Switch: Aan de slag handleiding (37 pagina's), Quickspecs (12 pagina's), Release Release (41 pagina's), Release Release (27 pagina's), Release Release (23 pagina's), Release Release (21 pagina's), Installatiehandleiding (21 pagina's)

Pagina afdrukken

Cisco 3020 - Cisco Catalyst Blade Switch Aan de slag handleiding

Using Express Setup

Before you complete the setup program, obtain the default gateway IP address and the switch

password from your system administrator. Depending on whether you are running Express Setup on

a Cisco Catalyst Blade Switch 3120 for HP switch module or a Cisco Catalyst Blade Switch

3020 for HP switch module, you can configure these optional parameters through the Express Setup

program:

• Telnet access password

• Names of the SNMP read and write community strings if you are going to use a

network-management program like CiscoWorks.

• Host name, system contact, and system location

• System time, time zone, Daylight Savings Time enable

Follow these steps to finish setting up the switch module. The Onboard Administrator assigns an

IP address and a subnet mask to the management interface (VLAN ID) and to the Ethernet

management port.

Step 1

Enter this information in the Network Settings fields.

In the Default Gateway field, enter the IP address for the default gateway (router).

–

In the Switch Password field, enter your password. The password can be from 1 to 25

–

alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces,

but does not allow spaces at the beginning or end.

In the Confirm Switch Password field, enter your password again.

You can enter the Optional Settings information now or enter it later by using the device manager

interface.

The fields in the Express Setup page depend on the type of switch module. Not all fields are

Note

available in the Cisco Catalyst Blade Switch 3020 for HP switch module Express Setup page.

Some of the settings are on the Advanced Settings tab for the Cisco Catalyst Blade Switch

3120 for HP switch module (see Figure 8).