Cisco 3600 Series Configuratie Opmerking - Pagina 7

Blader online of download pdf Configuratie Opmerking voor {categorie_naam} Cisco 3600 Series. Cisco 3600 Series 23 pagina's. Memory upgrade
Ook voor Cisco 3600 Series: Productoverzicht (10 pagina's), Upgrade-instructies (30 pagina's), Gebruikershandleiding (17 pagina's), Toepassingsnotitie (41 pagina's), Configuratiehandleiding (36 pagina's), Gebruikershandleiding (25 pagina's), Bijlage (15 pagina's), Gebruikershandleiding (7 pagina's), Handmatig (5 pagina's), Configuratie Opmerking (18 pagina's), Configuratie Opmerking (25 pagina's)

Removing the Cover

To gain access to the power supply of a Cisco 3600 series router, you must ﬁrst remove the chassis

cover.

Warning

AC units; disconnect the power at the circuit breaker on DC units. (To see translated versions of this

warning, refer to the Regulatory Compliance and Safety Information document that accompanied the

router.)

Warning

power switch, line voltages are present within the power supply even when the power switch is off

and the power cord is connected. For systems without a power switch, line voltages are present

within the power supply when the power cord is connected. (To see translated versions of this

warning, refer to the Regulatory Compliance and Safety Information document that accompanied the

router.)

Follow this procedure to remove the chassis cover:

Step 1

Warning

activity. (To see translated versions of this warning, refer to the Regulatory Compliance and Safety

Information document that accompanied the router.)

Step 2

Step 3

Warning

the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that

services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of

the circuit breaker in the OFF position. (To see translated versions of this warning, refer to the

Regulatory Compliance and Safety Information document that accompanied the router.)

Warning

disconnected last. (To see translated versions of this warning, refer to the Regulatory Compliance

and Safety Information document that accompanied the router.)

Before working on a chassis or working near power supplies, unplug the power cord on

Do not touch the power supply when the power cord is connected. For systems with a

Turn OFF power to the router.

Do not work on the system or connect or disconnect cables during periods of lightning

Remove all network interface cables from the rear panel.

If you have an AC-powered router, remove the power cord.

The following warnings apply to routers with DC power supplies:

Before performing any of the following procedures, ensure that power is removed from

When installing the unit, the ground connection must always be made ﬁrst and

Cisco 3600 Series Power Supply Configuration Note

Removing the Cover