Argo BOBO Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Argo BOBO. Argo BOBO 10 pagina's. Digital ceramic fan heater

Connect the power cord to an appropriate power outlet (220-240V ~ 50-60Hz).

Press the power button located on the back of the fan heater, a beep will sound. The display will show –

Then press the Standby button

button to turn off the device.

It is advisable to unplug the power cord if the product is not in use.

1. Standby button

Press this button on the control panel or remote control to turn the fan heater on or off.

2. Swing button

Press this button on the control panel or on the remote control to activate the horizontal oscillation of the fan heater. To

deactivate the swing function, press this button again.

3. Timer button

Press the Timer button on the control panel or remote control to select the operating interval in the following circular

sequence 0h (disable Timer), 1h, 2h, 3h ... up to 9 hours. Each time the button is pressed, the adjustment interval will be

1 hour. When the Timer function is activated, the time remaining before shutdown appears on the display.

4. Display

5. Temperature setting button

Touch on the button

6. Power setting button

Touch on the button

Mode

Working

status

V 05/21

CONTROL PANEL

on the control panel or remote control to turn on the fan heater. Press the same

to set the target temperature from 10℃15℃20℃23℃27℃30℃ in a continuous cycle.

to set the working mode as below in a continuous cycle:

Low heating

Fan mode

1350W

High heating

2000W