Argo DAKOTA Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Argo DAKOTA. Argo DAKOTA 10 pagina's. Electric convector heater

Temperature selection buttons

Press the buttons on the control panel to select the desired temperature between 10 ° C up to 35 ° C.

When the temperature reaches 10 ° C, press the button

will appear on the display

Timer Button and Display Illumination

Timer function: Press and hold the button

and

buttons to select the operating interval from 1 to 9 hours (the time increases by 1 hour at each

selection), on the display the set time will be shown.

Display lighting function: The standard lighting is 100%, press the button

lighting in the following circular sequence 100% -> 50% -> 25% -> 0%

When the lighting intensity is 0%, the display is off, the Standby button

button

are always lit with a lighting intensity of 25%, if no selection is made.

ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.

IMPORTANT: DO NOT SUBMERGE THE CONVECTOR IN WATER.

Cleaning the outside surface of the appliance

Turn the switch off and unplug before carrying out any maintenance work or moving the appliance.

Use a soft cloth to remove any dust from the convector.

If the convector is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower

than 50°C. Let the convector dry completely before use.

Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water.

chemical substances or other items to clean that may damage the surface.

Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.

STORAGE

If the appliance is not used for prolonged periods, it must be stored together with this manual in its original packaging, in

a cool and dry place.

V 05/21

and

. When the anti-freeze function is active, the reference temperature is 7 ° C.

for about 3 seconds, the display will show 0h, then press the

MAINTENANCE AND STORAGE

and the anti-freeze function will be activated,

to change the intensity of the

and the Timer / Display lighting

Do not use oils,