Argo IP24 Gebruiksaanwijzing - Pagina 9
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Argo IP24. Argo IP24 10 pagina's. Electric convector heater with glass panel
Pagina afdrukken
TIMER button
When the appliance is operating, the operating
time can be set by touching this button: the
timer display shows a flashing 0 and pressing
TIMER you can set the desired time, between
0,5 and 8 hours, with each touch
corresponding to half and hour.
The display shows the set time: wait 5" for the
setting to be confirmed. The unit will switch off
automatically at the end of the programmed time
(stand by).
In order to switch it on again press the button
ON/OFF.
If a TIMER is set the LED
ON/OFF buttons
Touching the ON/OFF button will cause the ECO
LED to light and the appliance will begin to
operate in ECO mode.
The display will show ambient temperature.
Touching the button ON/OFF once again the
LED will show room temperature.
To switch off the convector completely, place
the on/off switch in the "0FF" position.
WARNING: THE TEMPERATURE SELECTION BUTTON IS ACTIVE ONLY IN COMFORT MODE.
The appliance is fitted with an anti tip-up device that prevents it from operating when it detects that the product is inclined.
Do not position the appliance on its side or upside down.
TIMER button
The remote control uses Lithium/Manganese button cells, model no. CR2032-3 V, compliant with Battery Directive no.
2006/66/CE (supplied with the remote control).
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below)
Open the battery cover at the rear of the remote control (press and pull the cover).
Place the battery into the cover, observing the correct polarity. Insert the cover onto the remote control.
V 09/16
CONTROL PANEL
remains on.
REMOTE CONTROL
ON/OFF button
TEMPERATURE button
When COMFORT mode has been set, touching
this button will allow you to set the
temperature: the display will show ambient
temperature and, by pressing this button, the
desired temperature can be set between 5 and
35°C. Once the desired temperature has been
set, wait 5" for the setting to be confirmed. After
5" the display will show the ambient temperature
once again.
This function is active only in COMFORT
mode.
ON/OFF switch
TEMPERATURE
button
ECO/SUPER/COMFORT selection
button
- ECO mode: 750 W, reduced power to save
energy
- SUPER mode: maximum heating power
(1500W)
- COMFORT mode: automatic adjustment of
heat emission according to set temperature
ECO is the default mode.
Mode selection
button ECO, SUPER
or COMFORT
20