Cisco 7246 - uBR Router configureren - Pagina 22

Blader online of download pdf configureren voor {categorie_naam} Cisco 7246 - uBR Router. Cisco 7246 - uBR Router 28 pagina's. 7200 series port adapter hardware configuration guidelines
Ook voor Cisco 7246 - uBR Router: Gebruikershandleiding (7 pagina's), Aanvullende handleiding (42 pagina's)

Pagina afdrukken
Cisco 7246 - uBR Router configureren
Activate Host-to-Host Communication (Proxy ARP)
Activate Address Resolution Protocol Requests
To activate ARP requests, use the following command in cable interface configuration mode:
Command
cable arp
Validation Tips
To verify if ARP has been activated, enter the command more system:running-config and look for
the cable interface configuration information. If ARP has been activated, it does not appear in this
output. If ARP has been deactivated, it will appear in the output as no cable arp as shown in this
command output excerpt:
router# more system:running-config
Building configuration...
Current configuration:
!
interface Cable6/0
!
Troubleshooting Tips
If you are having trouble, make sure you entered the correct port and modem card slot number when
you activated ARP and when you entered the show interface cable command.
Activate Host-to-Host Communication (Proxy ARP)
Proxy ARP allows the Cisco uBR7246 to issue ARP requests on behalf of cable modems on the same
cable network subnet.
Note
perform ARP with other modems on the cable plant.
Note
adequate to configure the Cisco uBR7246.
VC-154
Voice, Video, and Home Applications Configuration Guide
ip address 1.1.1.1 255.255.255.0
no keepalive
no cable arp
cable insertion-interval 150000
cable downstream annex B
cable downstream modulation 64qam
cable downstream interleave-depth 32
cable downstream symbol-rate 5056941
cable upstream 0 frequency 15008000
cable upstream 0 fec
cable upstream 0 scrambler
no cable upstream 0 shutdown
Because the downstream and upstreams are separate interfaces, modems cannot directly
The default values for the commands used in this configuration task are, in most cases,
Purpose
Enable ARP.