Cisco 7507 Snelstarthandleiding - Pagina 12

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 7507. Cisco 7507 44 pagina's. Air filter and chassis blower replacement
Ook voor Cisco 7507: Handleiding voor installatie-instructies (39 pagina's), Gegevensblad (11 pagina's), Handleiding vervangende instructies (21 pagina's)

Install the Hardware

Install Interface Processors, Fillers, VIPs, or RSPs

Card carrier guide (black)

Captive

installation

screw

The Route Switch Processor (RSP) comes uninstalled

with your Cisco 7507 router, but is a required system

component. Install the RSPs in the slot 2 or slot 3,

and install any interface processors, ﬁllers, or

Versatile Interface Processors (VIPs) in slots 0, 1, 4,

5, and 6 (optional).

Step 1

Hold the interface processor, ﬁller, VIP, or

RSP with one hand, and place your other

hand under the carrier to support the card

and guide it into the slot. Avoid touching

the card.

Step 2

Place the interface processor, ﬁller, VIP, or

RSP in the slot and align the guide on the

carrier with the groove in the slot.

Step 3

Carefully slide the interface processor,

ﬁller, VIP, or RSP into the slot until the

faceplate makes contact with the ejector

levers.

Step 4

Use the thumb and foreﬁnger of each hand

to push the ejector lever ﬂat against the

interface processor, ﬁller, VIP, or RSP.

Step 5

Use a screwdriver to tighten the captive

installation screws.

Step 6

Repeat Step 1 through Step 5 to install

any additional interface processors, ﬁllers,

VIPs, or RSPs.

Step 7

To check an RSP installation, refer to the

"Check the RSP Installation" section on

page 30, and refer to the "Check the

Interface Processor or VIP Installation"

section on page 31 to check the interface

processor or VIP installation.