Argo Wallner S580 Gebruiksaanwijzing - Pagina 11
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Argo Wallner S580. Argo Wallner S580 13 pagina's.
Pagina afdrukken
sErVicE
Proceed only with routine actions according to the manual. do not repair or service ma-
chines on your own. Unplug the machine from the circuit and contact seller when one or
more of the following faults occur:
•
liquid gets into the machine
•
machine malfunctions as a result of improper use
•
machine does not work accordingly to the manual
PrOBLEM sOLViNG
problems
No operation
No operation after
long time operation
stop at shredding
Excess squeaking
and rubbing noise
Paper jam
© arGO s.a.
EN
checklists
The power plug is properly
inserted to main supply?
switch is set at „aUTO" position?
switch at „aUTO" position but
power light off.
Basket at stand but power light
off.
No operation when insert paper?
checked above but no operation
and no power light.
Power lamp is on?
Machine is continuously
shredding for a long time?
Without oiling to the cutting
system periodically.
- squeaking and rubbing noise at
shredding.
-
Exceeding
the
shredding
capacity
- The paper is not fed squarely
into the feed opening.
11
solutions
Fully put the power plug to the
outlet.
set switch to „aUTO" position
for operation.
check basket is out of stand.Put
basket back to stand.
Basket should be put into stand
to trigger the safety interlock
switch for operation.
Paper should be inserted to
trigger the sensor at center.
send back to your local service
for repair.
Unplug the
machine
main supply. allow
to
down to
room temperature
and resuming operation.
Unplug the
machine
main supply. allow
to
down to
room temperature
and resuming operation.
Perform
the
cutter
instruction to lubricate the
cutting system.
set switch to „rEV" for reverse
running and frees excess paper.
Then set to „aUTO" for cutting
the remainder of paper left in
the cutting system. if serious
jim occurred, send back to local
service for repair.
www.argo.pl
from
cool
from
cool
oiling