DIGITEN WTC200 Gebruikershandleiding - Pagina 7
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DIGITEN WTC200. DIGITEN WTC200 8 pagina's.
Ook voor DIGITEN WTC200: Gebruikershandleiding (9 pagina's), Gebruikershandleiding (12 pagina's)
Pagina afdrukken
change the number. Short press SET button to set next valve, or long press
the SET button to exit and save. Use this method to set the
RUN/STOP/Delay/HIGH/LOW value respectively. After setting all the
parameters, press and hold the SET button to exit and save. If there is no
action taken for 30 seconds, setting mode will be exited and any changed
will not be saved.
NOTE: In the setting state, long press the
change the setting value.
2. Example
In cooling mode, you want to keep room temperature at 77F，High alarm at
88F, Low alarm at 70F.
Long press SET button until
1)
setting value flashes.
Press
2)
Short press SET button to toggle between High and Low value.
3)
Long press SET to save and exit.
4)
Restore factory settings
POWER OFF, press and hold the SET button to power on at the same time.
After a long beep, all values are restored to the factory settings.
Default settings
Setting
Function
Temp unit
Temperature unit
Run
Run temperature value
Stop
Stop temperature value
High
High alarm value
Low
Low alarm value
Delay
Delay protecting time
or
to set the RUN at 77F, STOP is 75F.
or
button to continuously to
appears on the display ，and the
Setting range
℃/℉
0-70℃
32-158℉
0-70℃
32-158℉
0-70℃
32-158℉
0-70℃
32-158℉
0-10 minutes
Default value
℉
20℃
68℉
28℃
82℉
70℃
158℉
0℃
32℉
0