ACU-RITE 1113777-NN Software bijwerken - Pagina 5

Blader online of download pdf Software bijwerken voor {categorie_naam} ACU-RITE 1113777-NN. ACU-RITE 1113777-NN 5 pagina's.
Ook voor ACU-RITE 1113777-NN: Software bijwerken (6 pagina's), Software bijwerken (5 pagina's), Software bijwerken (6 pagina's), Software bijwerken (5 pagina's), Software bijwerken (6 pagina's), Software bijwerken (6 pagina's), Software bijwerken (7 pagina's), Software bijwerken (3 pagina's), Software bijwerken (6 pagina's), Software bijwerken (3 pagina's), Software bijwerken (3 pagina's)

These enhancements/changes were made:



The Bottom Finish will now take the value of 0 if it is not specified. Previously, if Bottom

Finish was blank, it would use the same value as the Side Finish field.



A consistent terminology "Software Travel Limit" is used now instead of 'Table Limit' or

'Software Limit'.



The tool retract between Z passes for Rectangle pocket, Rectangle slot and Circle

pocket is now set to Z begin.



The amount of motion allowed in the W-Axis while running a program or Single Cycle is

now configurable via Advanced Configuration. The default of 2mm can be changed at

Axes->ParameterSets->PW->CfgControllerAuxil->checkPosStandstill. A value of "0"

disables the monitoring and allows any amount of motion in the W-Axis without error.



The Helix step now defaults to CW to represent a more common right-handed thread.



Fixed an issue where the PNG file was not updated when a loaded MPT file was

modified and saved.



Fixed an issue where the file text preview was not updated when a modified program

was saved.



Fixed an issue where the Helix function was available in the two axis mode.



Fixed an issue in Program Functions where the file view location was not automatically

switched to the USB drive when inserted.



Fixed an issue where the program step popup was not automatically closing when

switching from PGM to DRO mode.



Fixed an issue where the blend fails to calculate in certain scenarios when a rotated,

repeated or mirrored geometry was exploded.



Fixed an issue where the blockform calculation is off when the offset is different.



Z-retract error message is now updated to be at least 0.01" (or 0.2mm) higher than the

programmed values for consistency.

If any issues are encountered, please contact your service representative for assistance or

contact technical support at

if you have any questions.