Argo L400A Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Argo L400A. Argo L400A 10 pagina's. Laminating machine with trimmer

Not applicable for one-side lamination only.

Sensitive paper as fax paper or its similar material can only be proceeded with „COLD"

lamination mode.

For best laminating results of your photos and certificates, it is recommended to wait

for RED light to illuminate before laminating.

Do not laminate exceeding the maximum thickness of 0.5mm. Laminating pouch

from 80-125 microns (3-6 mils.) can be used to laminate the standard DIN A4 70gsm

paper, but it is adviced to use only the 80 microns pouch for laminating thicker papers

or photos.

Regular maintenance of laminating rollers by the use of the specialized cleaning

paper can lessen laminator jam occurrence.

When the laminated material happens to get stuck during the lamination process,

which makes impassible to pull out by RELEASE / REVERSE Button, avoid the dange-

rous attempt of trying to open or dismantle the machine by your own.

The machine does not require any maintenance or adjustment. Please do not attempt

to take out the machine casing by yourself. If unusual problem occur, please contact

our after-sales service centers for the proper repair.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

10. While wearing a tie or long necklace, be cautions to keep these items away from

opening.

TRIMMER

WAY OF USING

Put the trimmer on the flat, stable surface.

Pull off the fixing unit backwards

Place the paper or material that you intend to cut in the required position on the

cutting base. Then click down the fixing unit to lock the paper.

Push the cutting unit along the edge of the metal cutting base.

NOTE!

It is forbidden to cut bigger amounts of paper than stated in instruction, it could cause

sliding out the rotating blade over the cutting zone and cause permanent damages of

blades.

There is a rule in all trimmers - the bigger amount of sheets cut at a time – the smaller

quality of cutting.

HOW TO CHANGE THE CUTTING UNIT

The L400A is supplied by 3 different blades. The blades are arranged in the three storage

compartments at the side of the trimmer.

Lift up the cutting device.

Pull out the blade.

Replace the blade by your chosen blade from the storage compartments at the side

of the trimmer.