Sony MHC-V3 Gebruiksaanwijzing - Pagina 28
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Sony MHC-V3. Sony MHC-V3 36 pagina's.
Pagina afdrukken
• The music data itself contains noise, or
the sound is distorted. Noise may have
entered during the transfer process.
Delete the file, and try transfer again.
• The bit rate used when encoding audio
files was low. Send audio files with
higher bit rate to the USB device.
"READING" is displayed for an
extended time, or it takes a long time
before playback starts.
• The reading process can take a long time
in the following cases.
– There are many folders or files on the
USB device (page 11).
– The file structure is extremely
complex.
– The memory capacity is excessive.
– The internal memory is fragmented.
"OVER CURRENT" appears.
• A problem has been detected with the
level of electrical current from the
port. Turn off the system and remove
the USB device from the port. Make
sure there is no problem with the USB
device. If this display pattern persists,
contact your nearest Sony dealer.
Erroneous display.
• The data stored in the USB device may
have been corrupted, perform the
transfer again.
• The character codes that can be
displayed by this system are numbers
and alphabets only. Other characters
that cannot be displayed appear as "_".
The USB device is not recognized.
• Turn off the system and reconnect the
USB device, then turn on the system.
• Check the information on the website
about compatible USB devices
(page 25).
• The USB device does not work
properly. Refer to the operating
instructions of the USB device on how
to deal with this problem.
28
GB
Playback does not start.
• Turn off the system and reconnect the
USB device, then turn on the system.
• Check the information on the website
about compatible USB devices
(page 25).
Playback does not start from the first
file.
• Set the play mode to Normal Play
(page 11).
Audio file cannot be played back.
• USB devices formatted with file
systems other than FAT16 or FAT32 are
unsupported.*
• A WMA audio file that is created in the
WMA DRM, WMA Lossless, or WMA
PRO format cannot be played back.
• An AAC audio file that is created in the
AAC DRM or AAC Lossless format
cannot be played back.
• AAC audio files encoded at 96 kHz
cannot be played back.
• If multiple partitions exist on a USB
device that is being used, files may not
be played back.
• The system can play back to a depth of
8 folders only.
• Files that are encrypted or protected by
passwords cannot be played back.
• Files with DRM (Digital Rights
Management) copyright protection
cannot be played back by this system.
• The MP3 PRO audio file can be played
back as MP3 audio file.
* This system supports FAT16 and FAT32, but
some USB devices may not support all of
these FAT. For details, refer to the operating
instructions of each USB device or contact the
manufacturer.