Cisco ASA 5585-X Onderhoudshandleiding - Pagina 22

Blader online of download pdf Onderhoudshandleiding voor {categorie_naam} Cisco ASA 5585-X. Cisco ASA 5585-X 44 pagina's. Maintenance and upgrade procedures
Ook voor Cisco ASA 5585-X: Snelstarthandleiding (40 pagina's), Snelstarthandleiding (6 pagina's)

Pagina afdrukken

Removing and Installing the Power Supply Module

Note

Figure 4-18

Source DC negative (–) cable

Source DC ground cable

Route the two source DC cables out of the terminal block, position the terminal block cover over the

Step 9

terminal block, and snap the cover into place

and the bottom clips on the terminal block cover have fully engaged the tabs on the terminal block.

Caution

To prevent short circuit or shock hazard after wiring the DC-input power supply, you must re-install the

terminal block cover.

Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide

4-22

The terminal block on the 1150 W DC-input power supply is labeled negative (–)—that is,

the two left-side posts—and positive (+)—the two right side posts. The ground post is

located on the DC-input power supply faceplate, separate from the terminal block.

Attaching the Source DC Cables to the Power Supply Module

Chapter 4

Maintenance and Upgrade Procedures

Source DC positive (+) cable

(Figure 4-19 on page

4-23). Make sure that both the top

OL-22567-02