Cisco ASA 5585-X Onderhoudshandleiding - Pagina 5
Blader online of download pdf Onderhoudshandleiding voor {categorie_naam} Cisco ASA 5585-X. Cisco ASA 5585-X 44 pagina's. Maintenance and upgrade procedures
Ook voor Cisco ASA 5585-X: Snelstarthandleiding (40 pagina's), Snelstarthandleiding (6 pagina's)
Pagina afdrukken
Chapter 4
Maintenance and Upgrade Procedures
On the front panel of the SSP, ensure the HDD1 (left hard disk drive) and HDD0 (right hard disk drive)
Step 3
indicators are flashing green to indicate that the drives are active.
Installing and Removing Cisco ASA 5585-X Network I/O
Modules
The ASA 5585-X comes with a core Security Services Processor (SSP-10, SSP-20, SSP-40, or SSP-60)
already installed in slot 0. You can install one or two of the following optional network I/O modules in
slot 1, which you divide into two slots using the accompanying slot divider:
•
•
•
The network I/O module is not hot-swappable, so you must power off the ASA 5585-X before installing
or removing the module. You must have a Phillips head screwdriver to install the slot divider that divides
slot 1 into two bays.
The ports are numbered right to left, with port 0 being the far right port and the far left port is either port
3, 7, or 19 depending on whether you have a 4-, 8-, or 20-port module. The 20-port numbers go from top
to bottom, and right to left. For slot 1 (top right slot), the interface is named TenGigabitEthernet 1/0
through TenGigabitEthernet 1/3. For slot 2 (top left slot) the interface is named TenGigabitEthernet 2/0
through TenGigabitEthernet 2/7.
OL-22567-02
SF P1
SF P0
7
6
5
4
3
SF P1
SF P0
7
6
5
4
3
Cisco ASA 5585-X 4-port 10-G Network I/O Module
Cisco ASA 5585-X 8-port 10-G Network I/O Module
Cisco ASA 5585-X 20-port 1-G Network I/O Module
Installing and Removing Cisco ASA 5585-X Network I/O Modules
2
1
0
0
1
MG MT
0
1
US B
2
1
0
0
1
MG MT
0
1
US B
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
AU X
CO NS OL
RE SE T
E
AU X
CO NS OL
RE SE T
E
4-5