ACU-RITE MILLPWR G2 Software bijwerken - Pagina 5

Blader online of download pdf Software bijwerken voor {categorie_naam} ACU-RITE MILLPWR G2. ACU-RITE MILLPWR G2 6 pagina's.
Ook voor ACU-RITE MILLPWR G2: Software bijwerken (6 pagina's), Software bijwerken (6 pagina's), Software bijwerken (6 pagina's)

Pagina afdrukken

For AMI Spindle Control systems, spindle information is now displayed below the Z axis field in

the DRO screen. Also, the active/programmed spindle RPM can be quickly set by pressing the

black axis key directly to the right of the spindle display area.

Added ability to edit G code values for addresses R, D, U & W in drilling cycles; previously, it

was not possible to edit the values for addresses.

It is now possible to send remote assistance requests from a MILLPWR

system to a service

agent whom use Remote Diagnostics PC software.

Enhanced the Repeat step to also support array and frame patterns.

A Redraw softkey (F6) has been added when in the View form dialogue. Redraw performs the

same as the decimal point hot-key. In addition, both methods now re-draw graphics when

pressed.

Enhanced the Change Steps feature to allow changes to Z Pass and Z Peck.

All of the settings in the View dialog are now saved and restored upon reboot, with the

exception of Pan, Zoom, Rotate, and Dry Run Speed.

Programming of the "staging" point for custom pockets is now optional. Moves to this point are

eliminated when no location is provided. If the "staging" point is programmed, moves to this

location at the start and end of the step are still executed.

The PLC has been updated. Any OEM/User customizations to the PLC will need to be

reintegrated into the new PLC project.

The graphics ruler is now also displayed while running a program in the 2D Line View.

Added support for setting a datum during single cycles.

Soft travel limit messages updated to indicate which limit was exceeded.

The NcKernel base was updated to Milestone 10 Service Pack 4.

These errors have been corrected:

Corrected possible tool path issues when using repeat/rotate/mirror steps.

Removed the option to delay the required reboot after changing settings in the Network Settings

dialog, as delaying it could cause unexpected issues.

AUX Function step does not break path continuity when it neighbors a Blend step.