Cisco ASR 9000 Series Handmatig - Pagina 12
Blader online of download pdf Handmatig voor {categorie_naam} Cisco ASR 9000 Series. Cisco ASR 9000 Series 44 pagina's. Line card
Ook voor Cisco ASR 9000 Series: Netwerkinstellingen configureren (26 pagina's), Configuratiehandleiding (46 pagina's), Configuratiehandleiding (50 pagina's), Handmatig (24 pagina's), configureren (46 pagina's), Snelle referentiehandleiding (7 pagina's)
Pagina afdrukken
- 1. Field Replaceable Units
- 2. Online Insertion and Removal
- 3. Powering off the Router
- 4. Replacing the Chassis Air Filter
- 5. Required Tools and Equipment
- 6. Removing a Fan Tray
- 7. Installing a Fan Tray
- 8. Disconnecting AC Power
- 9. Reconnecting AC Power
- 10. Disconnecting DC Power
- 11. Reconnecting DC Power
Removing and Replacing Power System Components
Procedure
Step 1
Lift the fan tray (with two hands) and slide it halfway into the module bay.
Step 2
Slowly push the fan tray into the chassis until it mates with the backplane connector at the back of the module
bay.
Caution
Step 3
Tighten the captive screw(s) on the fan tray using the 6-inch long number 2 Phillips screwdriver to a torque
of 10 +/–1 in-lb to secure it to the chassis.
Step 4
Verify that the (green) OK status indicator on the front of the fan tray goes on. If the OK indicator does not
light, see
Removing and Replacing Power System Components
The Cisco ASR 9000 Series Routers support OIR of power modules. If you are replacing a redundant power
module, you can remove and install the power module while the system remains powered on without causing
an electrical hazard or damage to the system. This feature enables you to replace a power module while the
system maintains all routing information and ensures session preservation.
However, to maintain operational redundancy and proper cooling, and to meet EMI compliance standards,
you must have at least one working power module installed (more than one for a fully configured system).
When you remove a failed power module with the router in operation, perform the replacement as quickly as
possible. Make sure you have the replacement power module ready before beginning the removal and installation
procedure.
Note
For the RSP/RP to communicate properly to a power module in a power tray, input power to at least one of
the power modules in the power tray should be present.
This section contains procedures on how to remove and install AC and DC power modules used in the Cisco
ASR 9000 Series Routers.
Caution
Do not turn off the switch on the power tray to remove individual power modules. Power modules support
OIR, so they can be removed and replaced with the power on and the system operating.
Changing Between Version 1, Version 2, Version 3, AC, and DC Power Modules
Note
The pwrmod_change command is not supported on the Cisco ASR 9912 Router and Cisco ASR 9922 Router.
Follow these steps when changing between version 1, version 2, version 3, AC, and DC power modules:
Replacing Cisco ASR 9000 Series Router Components
12
To prevent damage to the connectors, do not use excessive force when inserting the fan tray into
the chassis.
Troubleshooting the Cooling
Replacing Cisco ASR 9000 Series Router Components
Subsystem.