Cisco ASR 9922 Handmatig - Pagina 33
Blader online of download pdf Handmatig voor {categorie_naam} Cisco ASR 9922. Cisco ASR 9922 44 pagina's. Replacing cisco asr 9000 series router components
Pagina afdrukken- 1. Field Replaceable Units
- 2. Online Insertion and Removal
- 3. Powering off the Router
- 4. Replacing the Chassis Air Filter
- 5. Required Tools and Equipment
- 6. Removing a Fan Tray
- 7. Installing a Fan Tray
- 8. Disconnecting AC Power
- 9. Reconnecting AC Power
- 10. Disconnecting DC Power
- 11. Reconnecting DC Power
Replacing Cisco ASR 9000 Series Router Components
0/FC6
0/PT1
0/PT2
0/PT3
Step 14
Repeat Step 6, Step 7 and Step 8.
Step 15
(Optional) Perform FPD upgrade on RP3. Use these commands:
Note
Example:
sysadmin-vm:0_RP1# upgrade hw-module location 0/RP0 fpd
sysadmin-vm:0_RP1# upgrade hw-module location 0/RP1 fpd
Step 16
Reload the system once FPDs are upgraded using the admin hw-module location all reload command.
Migrating from RSP440 to RSP880 or RSP880-LT Card
Before you begin:
• You must have console access to the router.
• The router must be running Cisco IOS XR software release 5.3.2 or later version to support RSP880.
• The router must be running Cisco IOS XR software release 6.2.2 or later version to support RSP880-LT.
• The router must have two RSP440 cards (active and standby) up and running.
• Cisco ASR 9000 Ethernet Line Card (first generation) must be removed from the chassis as they are
• Cisco ASR 9000 High Density 100GE Ethernet line cards (third generation) must be power down or
Procedure
Step 1
Use show redundancy summary command to identify the active and standby RSPs.
Example:
Router# show redundancy summary
Wed Jun 17 11:18:51.391 PST
Active/Primary Standby/Backup
-------------- --------------
0/RSP0/CPU0(A) 0/RSP1/CPU0(S) (Node Ready, NSR: Ready)
0/RSP0/CPU0(P) 0/RSP1/CPU0(B) (Proc Group Ready, NSR: Ready)
Make sure RSP1 is the active RSP card. If not, then use redundancy switchover command to
A99-SFC2
A9K-AC-PEM-V2
A9K-AC-PEM-V2
A9K-AC-PEM-V2
An FPD upgrade can be performed after the FCs and LCs are added to the system.
incompatible with RSP880.
temporarily removed before starting the migration procedure. Use the hw-module power disable location
node-id command in admin-config mode to power down the LC.
Migrating from RSP440 to RSP880 or RSP880-LT Card
OPERATIONAL
NSHUT
OPERATIONAL
NSHUT
OPERATIONAL
NSHUT
OPERATIONAL
NSHUT
Replacing Cisco ASR 9000 Series Router Components
33