Cisco Catalyst 7500 Series Handmatig vervangen - Pagina 25
Blader online of download pdf Handmatig vervangen voor {categorie_naam} Cisco Catalyst 7500 Series. Cisco Catalyst 7500 Series 40 pagina's. Chassis interface board
Ook voor Cisco Catalyst 7500 Series: Gegevensblad (11 pagina's), Handleiding voor probleemoplossing (11 pagina's), Configuratiehandleiding (50 pagina's)
Pagina afdrukken
Removing and Replacing the Backplane Maintenance Cover
The backplane maintenance cover provides EMI and ground protection for the backplane, the dual
arbiter, and the CI. To access these components, you must remove the backplane cover. You need a
number 2 Phillips screwdriver to remove the cover screws. Following is the procedure for removing
and replacing the backplane maintenance cover.
Note
appropriate procedures in this section to remove these items.
Step 1
Step 2
Figure 16
This procedure assumes you have already removed the front panels. If not, refer to the
Attach an ESD-preventive strap between you and an unpainted chassis surface.
Loosen the ten Phillips screws that secure the cover. (See Figure 16.)
Removing the Backplane Maintenance Cover
Replacing the Chassis Interface (CI) Board in the Cisco 7500 Series Chassis
Replacing the CI in the Cisco 7513
Loosen these
screws (10)
25