Cisco Content Engine 565 Installatiehandleiding - Pagina 20
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Cisco Content Engine 565. Cisco Content Engine 565 28 pagina's. Content engine
Pagina afdrukken
Checking the LEDs
Connect the other end of the power cord to a power source at your installation site.
Step 3
Power up all externally connected devices.
Step 4
Press the power control button on the front of the Content Engine.
Step 5
The system should begin booting. Once the operating system boots, you are ready to initialize the basic
software configuration. (Refer to the software configuration guide or user guide that shipped with your
system.)
Note
You can install a circular disk over the power control button to prevent accidental manual power down.
Note
This disk, known as the power control button shield, comes with your Content Engine.
Checking the LEDs
When the Content Engine is up and running, observe the front and back panel LEDs to verify that your
system is operating properly.
Figure 11
Figure 11
Table 2
Indicator
1
2
3
4
Figure 12
Installing the Cisco Content Engine 510 and 565
20
While the Content Engine is powering up, the green power LED (labeled 4 in
shows the location of front panel LEDs, and
Front Panel LEDs
1
Front Panel LEDs
Color
CD-ROM drive activity Green
System error
Amber
Hard disk drive activity Green
Power
Green
shows the location of back panel LEDs, and
Table 2
describes their function.
2
3
State
Description
On
The CD-ROM drive is in use.
On
A system error has occurred. An LED on the
diagnostic LED panel is also on to further
isolate the error.
Flashing
The associated hard disk drive is in use.
On
Power is flowing to the Content Engine.
Flashing
The Content Engine is in standby mode.
Table 3
describes the LED functions.
Figure
11) is on.
4
78-14731-02