Cisco CSC-C2FCIT Installeren en upgraden - Pagina 9

Blader online of download pdf Installeren en upgraden voor {categorie_naam} Cisco CSC-C2FCIT. Cisco CSC-C2FCIT 32 pagina's. Fddi card and appliques

•

Connect the equipment end of the strap to an unpainted surface of the chassis frame or another

proper grounding point or surface. We recommend that you attach it to the inside bottom of the

chassis, or to the rear panel (inside or outside), without making contact with any connectors or

appliques.

•

Avoid contact between equipment and clothing. The wrist strap only protects the equipment from

ESD voltages on the body; ESD voltages on clothing can still cause damage.

•

Handle printed circuit cards and appliques by the edges only; avoid touching the components,

traces, or any connector pins.

•

Place a removed card component-side-up on an antistatic surface or in a static shielding bag. If

the component will be returned to the factory, immediately place it in a static shielding bag.

•

Do not remove the wrist strap until the installation is complete.

Caution

measurement should be between 1 and 10 mega ohms.

Slot Priority

The AGS+ card cage, shown in Figure 8, has nine slots, ﬁve of which are designated ciscoBus slots.

The center ciscoBus slot is reserved for the ciscoBus card, leaving four ciscoBus slots available for

ciscoBus interface cards.

Figure 8

ciscoBus

slots

Note

The AGS+ uses a slot priority scheme that assigns a priority to each ciscoBus card according to the

ciscoBus slot in which the card resides. The card in ciscoBus slot 0 receives the highest ciscoBus

priority, while the card in ciscoBus slot 3 receives the lowest ciscoBus priority.

For safety, periodically check the resistance value of the antistatic strap. The

AGS+ Card Cage and Backplanes—Front View

Multibus or ciscoBus interface card

Multibus interface or ciscoBus controller card

Multibus or ciscoBus interface card

The ciscoBus currently supports a maximum of four C2FCIT cards.

Installing and Upgrading the CSC-C2FCIT FDDI Card and Appliques

Environmental monitor card

Processor card

Multibus interface card

Installation Prerequisites

Multibus

slots