Cisco Firepower 4110 Aan de slag - Pagina 9

Blader online of download pdf Aan de slag voor {categorie_naam} Cisco Firepower 4110. Cisco Firepower 4110 42 pagina's. Rack-mount and ground the chassis
Ook voor Cisco Firepower 4110: Handleiding voor onderhoud en upgrades (20 pagina's), Handmatig (36 pagina's), Handmatig (26 pagina's), Handmatig (8 pagina's), Handmatig (42 pagina's)

Pagina afdrukken

Getting Started

Procedure

Step 1

Using a browser, open the home page of the system, for example, https://ftd.example.com.

You can use any of the following addresses. You can use the IPv4 or IPv6 address or the DNS name, if you

have configured one.

• The management address. By default (on most platforms), the Management interface is a DHCP client,

• The address of a data interface that you have opened for HTTPS access. By default (on most platforms),

Tip

Step 2

Enter your username and password defined for the device, then click Login.

You can use the admin username, which is a pre-defined user. The default admin password is Admin123. On

AWS, the default admin password is the AWS Instance ID, unless you define a default password with user

data (Advanced Details > User Data) during the initial deployment.

Your session will expire after 30 minutes of inactivity, and you will be prompted to log in again. You can log

out by selecting Log Out from the user icon drop-down menu in the upper right of the page.

Logging Into the Command Line Interface (CLI)

Use the command-line interface (CLI) to set up the system and do basic system troubleshooting. You cannot

configure policies through a CLI session.

To log into the CLI, do one of the following:

• Use the console cable included with the device to connect your PC to the console using a terminal emulator

so the IP address depends on your DHCP server.

the "inside" interface allows HTTPS access, so you can connect to the default inside address 192.168.95.1.

See

Default Configuration Prior to Initial Setup, on page 26

address.

If you changed the HTTPS data port, you must include the custom port in the URL. For example, if you

changed the port to 4443: https://ftd.example.com:4443

If your browser is not configured to recognize the server certificate, you will see a warning about

an untrusted certificate. Accept the certificate as an exception, or in your trusted root certificate

store.

set for 9600 baud, 8 data bits, no parity, 1 stop bit, no flow control. See the hardware guide for your

device for more information about the console cable.

Logging Into the Command Line Interface (CLI)

for details about your model's inside IP

Getting Started