Cisco Firepower 4150 Handmatig - Pagina 24

Blader online of download pdf Handmatig voor {categorie_naam} Cisco Firepower 4150. Cisco Firepower 4150 26 pagina's. Rack-mount and ground the chassis
Ook voor Cisco Firepower 4150: Handleiding voor onderhoud en upgrades (20 pagina's), Handmatig (36 pagina's), Handmatig (8 pagina's), Handmatig (42 pagina's), Aan de slag (42 pagina's)

Pagina afdrukken

Install the FIPS Opacity Shield

8-32 x 0.375-inch Phillips screws (three per side)

Step 4

Attach a cable management bracket to each slide rail locking bracket using the four 8-32 x 0.375-inch Phillips screws

provided in the accessory kit.

Figure 16: Attach the Cable Management Bracket to the Slide Rail Locking Bracket

Cable management bracket

8-32 x 0.375 inch Phillips screws (two per side)

Step 5

Connect the cables to the ports. Install the cables according to your default software configuration as described in the

Cisco Firepower 4100 Getting Started

cable mounting brackets (as shown in Step 6 below).

Note

If you are installing the FIPS opacity shield after the initial product installation, the cables are connected. If

the attached cables do not have enough slack to route them through the cable mounting brackets (as shown

below), you will have to turn the power off on the appliance, remove the cables, route the cables through the

cable mounting brackets, reattach the cables, and continue with Step 7 below.

Step 6

Route the cables through the openings in the cable management brackets.

Installation, Maintenance, and Upgrade

Slide rail locking bracket

Guide. Make sure that the cables have enough slack to route them through the

Installation, Maintenance, and Upgrade