Cisco GS7000 Onderhoudshandleiding

Blader online of download pdf Onderhoudshandleiding voor {categorie_naam} Cisco GS7000. Cisco GS7000 15 pagina's. Gainmaker node forward local injection module
Ook voor Cisco GS7000: Handleiding voor installatie-instructies (13 pagina's), Problemen oplossen (4 pagina's), Handleiding voor probleemoplossing (12 pagina's)

Maintenance

This section describes maintenance procedures for the 1.2 GHz GS7000 Remote PHY Device (RPD) 2X2

Segmentable Node.

•

Opening and Closing the Housing

Installation or maintenance of the node requires opening the housing to access the internal modules.

Proper housing closure is important to maintaining the node in good working condition. Proper closure ensures

a good seal against the environment, protecting the internal modules.

Opening the Housing

Open the housing as follows.

1. Remove the bolts securing the lid to the base.

2. Carefully open the lid to allow access to the inside of the housing.

3. Inspect gaskets on the cover flange and on the test port plugs.

4. Replace any gaskets showing signs of wear (cracked, twisted, pinched, or dry) with new, silicon-lubricated

gaskets.

Closing the Housing

Close the housing as follows.

1. Ensure any worn gaskets are replaced, and the gaskets are clean and in the correct position.

2. Carefully close the lid.

Opening and Closing the Housing, on page 1

Preventative Maintenance, on page 2

Removing and Replacing Modules, on page 5

Care and Cleaning of Optical Connectors, on page 10

Maintenance