Cisco IAD2430 Series Snelstarthandleiding - Pagina 10

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco IAD2430 Series. Cisco IAD2430 Series 34 pagina's. Integrated access device
Ook voor Cisco IAD2430 Series: Overzicht handleiding (13 pagina's), Overzicht (16 pagina's)

Pagina afdrukken
Cisco IAD2430 Series Snelstarthandleiding
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040
Warning
Before opening the unit, disconnect the telephone-network cables to avoid contact with telephone-network
voltages. Statement 1041
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260. Incorrectly
connecting this equipment to a general-purpose outlet could be hazardous. The telecommunications lines must be
disconnected 1) before unplugging the main power connector or 2) while the housing is open, or both. Statement
1043
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
7

Installing the Chassis

This section provides the procedures for installing the chassis.
Chassis Installation Options
You can set the chassis on a desktop, install it in a rack, or mount it on a wall.
Before proceeding, consider the location of the equipment with respect to a good ground. See the "Grounding the
Tip
Chassis" section on page 18.
See the following instructions:
• Using the Correct Bracket Screws, page 10
• Connecting the RJ-21 Cable in the Velcro Harness, page 23
Use only the mounting hardware supplied with this product.
Caution
Using the Correct Bracket Screws
Two sets of bracket attachment screws are provided, in separate packages. Take care to use each screw type, and washers as
needed, in the appropriate locations. Table 1 summarizes the bracket attachment screw types for the Cisco IAD2430,
Cisco IAD2431, and Cisco IAD2432 IADs.
10