argon audio Radio 2i MK2 Handmatig - Pagina 13

Blader online of download pdf Handmatig voor {categorie_naam} argon audio Radio 2i MK2. argon audio Radio 2i MK2 16 pagina's.
Ook voor argon audio Radio 2i MK2: Snel aan de slag (2 pagina's)

Pagina afdrukken

6.5.2 Station order

You can choose the order of the DAB station list to be either Alphanumeric, Ensemble or Valid. Ensemble lists

groups of stations that are broadcast together on the same ensemble, for example BBC or South Wales local.

Valid lists valid stations first, alphanumerically, then off-air stations.

To change station order, select Menu > Station order > then Alphanumeric, Ensemble or Valid.

7. FM radio mode

FM radio mode receives analogue radio from the FM band and displays

RDS (Radio Data System) information about the station and show (where

broadcast).

To enter FM mode, either press Mode until the display shows FM Radio

or select Menu > Main menu > FM.

7.1 Selecting stations

To find a station, press Select . The frequency display starts to run up as Radio 2i MK2 scans the

FM band. Alternatively, you can scan up or down by pressing and holding the >> or << buttons

or tune manually with quick presses, or by turning the Select control.

7.2 Presets

To store an FM preset, press and hold Preset until the display shows the Save preset screen.

Select one of the 10 presets to save the currently playing station.

To select a preset, press Preset briefly, then select one of the listed preset stations. When a preset

station is playing, it shows Pn (P1, P2 etc) in the bottom right of the screen.

7.3 Now playing information

While an FM station is playing, the screen shows one of the two following sets data:

•

If RDS information is available, by default the service name (i.e. station name) is displayed.

You can cycle through further RDS information by pressing Info . Each time you

press Info , another set of information is displayed, cycling through RDS radio text,

RDS programme type, frequency and today's date.

•

If no RDS information is available, the currently tuned frequency is shown.

7.4 Settings

Scan settings

By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss) from

weak stations. To change the scan settings to stop only at stations with good signal strength,

select Menu > Scan setting > Strong stations only? > Yes.

Audio settings

By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor signal-to-

noise ratio (hiss). To play weak stations in mono, select Menu > Audio setting > FM weak reception: Listen

in mono only > Yes.

w w w . a r g o n a u d i o . c o m

R a d i o 2 i M K 2