Cisco PIX 506 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco PIX 506. Cisco PIX 506 8 pagina's. Chapter 3
Ook voor Cisco PIX 506: Snelstarthandleiding (18 pagina's)

Pagina afdrukken
Chapter 3
PIX 506/506E
Figure 3-4
Figure 3-4
Table 3-2
Table 3-2
LED
ACT
LINK
The USB port at the left of the Console port is not used.
Installing the PIX 506/506E
Place the PIX 506/506E on a flat, stable surface. The PIX 506/506E is not rack mountable.
To install the PIX 506/506E, perform the following steps:
Step 1
Connect the cable so that you have either a DB-9 or DB-25 connector on one end as required by the serial
port for your computer, and the other end is the RJ-45 connector.
Note
78-15170-02
shows the PIX 506/506E rear panel LEDs.
PIX 506/506E Rear Panel LEDs
ACT(ivity)
ACT(ivity)
LED
LED
LINK
LED
ACT
LINK
ACT
ETHE RNET 1
10BaseT
10BaseT
(RJ-45)
lists the states of the PIX 506/506E rear panel LEDs.
PIX 506/506E Rear Panel LEDs
Color
State
Green
On
Green
On
Use the RJ-45 Console port to connect a computer to enter configuration commands. Locate the
serial cable from the accessory kit. The serial cable assembly consists of a null modem cable
with RJ-45 connectors, and one DB-9 connector and one DB-25 connector.
LINK
LED
Power switch
LINK
ETHE RNET 0
USB
CON SOLE
USB
(RJ-45)
port
Console
port (RJ-45)
Description
Shows network activity.
Shows that data is passing on the network to which the
connector is attached.
Cisco PIX Security Appliance Hardware Installation Guide
Installing the PIX 506/506E
DC
POWE R
INPUT
3-3