Cisco RSP7000 Installing - Pagina 18

Blader online of download pdf Installing voor {categorie_naam} Cisco RSP7000. Cisco RSP7000 26 pagina's. Upgrade kit in the cisco 7000 series routers
Ook voor Cisco RSP7000: Installatie- en configuratiehandleiding (48 pagina's)

Pagina afdrukken

Installing the RSP7000 Upgrade Kit

Figure 9

Power switch

Chassis ground

screw

Step 5

Step 6

Step 7

Step 8

This completes the RP removal procedure.

Installing the RSP7000CI

The RSP7000CI is keyed for installation only in the RSP7000CI slot (slot 6 in the Cisco 7000, see

Figure 1, and slot 4 in the Cisco 7010, see Figure 2).

Note

Figure 7 for the Cisco 7010, both of which appear on page 10.

Caution

attempt to install the RSP7000CI in any other slot but the chassis' 7000 CI slot. Do not install the

RSP7000CI in the router's Switch Processor (SP) slot. You must install the RSP7000CI in the 7000

CI slot.

Follow these steps to install an RSP7000CI:

Step 1

18 Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

Cisco 7010 with RP and SP (or SSP) Installed

Power receptacle

Use a screwdriver (number 2 Phillips or 3/16-inch ﬂat-blade) to loosen the two captive

installation screws on the RP. (See Figure 5a on page 9.)

Place your thumbs on the ends of each of the ejectors and simultaneously pull them both

outward, away from the carrier handle (in the direction shown in Figure 5c on page 9) to

release the carrier from the slot and to dislodge the RP from the backplane.

Grasp the handle with one hand and pull the RP straight out of the slot, keeping your other

hand under the carrier to guide it. Keep the carrier parallel to the backplane. Avoid touching

the board or any connector pins.

Place the removed RP on an antistatic mat or foam. If you plan to return the RP to the

factory, immediately place it in an antistatic bag to prevent ESD damage.

For proper card orientation during this installation, refer to Figure 6 for the Cisco 7000 or to

To prevent damage to the chassis slot and to the connector on the RSP7000CI, do not

Grasp the RSP7000CI handle with one hand and place your other hand under the carrier to

support as you guide into the 7000 CI slot. Avoid touching the board or any connectors.

RP slot

SP or SSP slot

Interface processor slot 2

Interface processor slot 1

Interface processor slot 0

DC OK LED

AC-input power supply