Cisco TelePresence MCU MSE 8510 Aan de slag - Pagina 5

Blader online of download pdf Aan de slag voor {categorie_naam} Cisco TelePresence MCU MSE 8510. Cisco TelePresence MCU MSE 8510 16 pagina's. Getting started

Pagina afdrukken

Installing the MCU MSE 8510

Important

read the safety information guide for the MSE 8000 chassis at

http://www.cisco.com/go/telepresence/safety.

Although blades are hot-swappable parts, you must only remove one

blade at any time. Remove the power from the MSE 8000, if you need to

remove more than one blade at a time.

Before hot-swapping a blade, shut down the blade using the web interface.

Do not shut down a blade during a software upgrade or if the blade is

processing (for example if a conference is taking place on a blade).

The MSE 8000 backplane uses high performance data connectors. Do not

remove MCU MSE 8510 blades unless necessary because doing so may

reduce the life of these connectors.

Make sure that you have the correct power requirements and sufficient

power in your PSU; for information on powering the MSE 8000 refer to

the Getting Started Guide on

conferencing-documentation.jsp).

Step one: Install the MCU MSE 8510 into the MSE 8000 chassis

You must install either a blade or a blanking blade in each of the ten

positions in the chassis.

The Supervisor blade must be installed into slot 1 of the MSE 8000

chassis.

Remove the blade or blanking blade from the slot into which you are going to

install the MCU MSE 8510:

Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches

with an anti-clockwise quarter turn.

Open both retaining latches on the front of the blade or blanking blade.

When open, a retaining latch is at a 90

the blade.

: Before installing the MCU MSE 8510 into the MSE 8000,

http://www.tandberg.com/support/video-

Installing the MCU MSE 8510

angle perpendicular to the front of