Cisco TelePresence Server 7010 Handleiding vervangende instructies - Pagina 5

Blader online of download pdf Handleiding vervangende instructies voor {categorie_naam} Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 23 pagina's. 600w ac-input power supply and fan tray replacement
Ook voor Cisco TelePresence Server 7010: Handleiding voor installatie-instructies (15 pagina's), Installatiehandleiding (14 pagina's), Aan de slag (16 pagina's), Handleiding vervangende instructies (18 pagina's)

Lifting Safely

A fully conﬁgured chassis weighs approximately 70 pounds. Before installing the new

(replacement) chassis, ensure that your site is properly prepared, so you can avoid having to move

the chassis later to accommodate power sources and network connections.

•

Never try to lift an object that is too heavy for you to lift safely by yourself.

•

Ensure that your footing is solid and balance the weight of the object between your feet.

•

Lift the object slowly; never move suddenly or twist your body as you lift.

•

Keep your back straight and lift with your legs, not your back. If you must bend down to lift the

chassis, bend at the knees, not at the waist, to reduce the strain on your lower back muscles.

•

When lifting the chassis, grasp the underside of the chassis exterior with both hands. Do not

attempt to lift the end of the chassis with the handles on the interface processor carriers; these

handles are not designed to support the weight of the chassis.

•

Always disconnect all external cables before lifting or moving the chassis.

Preventing Electrostatic Discharge (ESD) Damage

Electrostatic discharge (ESD) damage, which can occur when electronic boards or components are

handled improperly, can result in complete or intermittent failures. The processor modules each

comprise a printed circuit board that is ﬁxed in a metal carrier. EMI shielding, connectors, and a

handle are integral components of the carrier. Handle processor modules by the metal frame or

carrier only; avoid touching the board (particularly avoid touching any components, connector pins,

or the metal ﬁngers on the edge connector).

Following are guidelines for preventing ESD damage:

•

Always use an ESD wrist strap or ankle strap and ensure that it makes good skin contact.

•

When removing or installing interface processors, connect the equipment end of the ground strap

to the chassis ground screw on the interface processor end of the chassis.

•

Place removed processor modules board-side-up on an antistatic mat or in a static shielding bag.

•

If you are returning a replaced part to the factory, immediately place it in a static shielding bag

to avoid ESD damage to the board.

•

Avoid contact between the board and clothing. The ESD strap only protects the board from ESD

voltages on the body; ESD voltages on clothing can still cause damage.

Note

should be between 1 and 10 megohms.

For safety, periodically check the resistance value of the antistatic strap. The measurement

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Prerequisites