Cisco UCS B200 M3 Installatie en onderhoud - Pagina 16

Blader online of download pdf Installatie en onderhoud voor {categorie_naam} Cisco UCS B200 M3. Cisco UCS B200 M3 28 pagina's. Blade server
Ook voor Cisco UCS B200 M3: Installatiehandleiding (34 pagina's), Installatie en onderhoud (36 pagina's), Installatie en onderhoud (37 pagina's), Handmatig (8 pagina's), Upgrade handleiding (21 pagina's)

Cisco UCS B200 M3 Installatie en onderhoud
Step 1
Required: To install a CPU in an empty socket, remove the protective cap that is intended to prevent bent or touched
contact pins. The pick and pull cap tool provided can be used in a manner similar to a pair of tweezers. Grasp the
protective cap and pivot as shown.
Step 2
Release the catch on the pick and pull tool by pressing the handle/button.
Step 3
Remove the new CPU from the packaging, and load it into the pick and place tool as follows:
a) Confirm that the pedestal is set up correctly for your processor. The pedestal ships configured with the markings
"LGA2011-R1" facing upward, and this is the correct orientation.
b) Place the CPU on the pedestal. The CPU corners should fit snugly at the pedestal corners and the notches should
meet the pegs perfectly.
c) Place the CPU pick and place tool on the CPU pedestal aligned with the A1 arrow pointing to the A1 registration
mark on the pedestal.
d) Press the button/handle on the tool to grasp the CPU.
e) Lift the tool and CPU straight up off of the pedestal.
Figure 12: Loading the Pick and Place Tool
1
Step 4
Place the CPU and tool on the CPU socket with the registration marks aligned as shown.
Step 5
Press the button/handle on the pick and place tool to release the CPU into the socket.
16
Alignment mark on the pick and place tool, CPU and
pedestal