Cisco 2500 Series Handleiding installeren - Pagina 9

Blader online of download pdf Handleiding installeren voor {categorie_naam} Cisco 2500 Series. Cisco 2500 Series 12 pagina's. Wireless controller
Ook voor Cisco 2500 Series: Configuratiehandleiding (19 pagina's), Uitrolhandleiding (23 pagina's), Configuratiehandleiding (50 pagina's), Aan de slag handleiding (47 pagina's)

Figure 9

DC Power Supply Connections

Ground

Terminal block

Warning

When stranded wiring is required, use approved wiring terminations, such as closed-loop or spade-type

with upturned lugs. These terminations should be the appropriate size for the wires and should clamp both the

insulation and conductor. (To see translated versions of this warning, refer to the Regulatory Compliance and

Safety Information document that accompanied your router.)

Do not overtorque the terminal block captive thumbscrew or terminal block contact screws. The

Caution

recommended torque is 8.2 0.4 inch-lb .

Warning

After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate

power by moving the handle of the circuit breaker to the ON position. (To see translated versions of this warning,

refer to the Regulatory Compliance and Safety Information document that accompanied your router.

Negative

Terminal block

Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers

Connecting the DC Power Supply

Positive

On/off