Cisco 7513 Series Snelstarthandleiding - Pagina 23

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 7513 Series. Cisco 7513 Series 44 pagina's. Chassis replacement
Ook voor Cisco 7513 Series: Handleiding vervangende instructies (26 pagina's), Gegevensblad (11 pagina's), Handmatig (30 pagina's), onderhouden (20 pagina's), Handleiding vervangende instructies (19 pagina's), Handleiding vervangende instructies (22 pagina's)

Step 2

Determine which protocols you want to allow on the synchronous serial interface and enter the

appropriate responses:

Configure IP unnumbered on this interface? [no]:

IP address for this interface: 1.1.1.20

Number of bits in subnet field [0]:

Class A network is 1.0.0.0, 0 subnet bits;

mask is 255.0.0.0

Configure IPX on this interface? [no]: yes

IPX network number [2]:

Configure AppleTalk on this interface? [no]:

yes

Extended AppleTalk network? [no]:

AppleTalk network number [1]:

Step 3

Press Ctrl-Z to exit conﬁguration mode.

Step 4

At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

Your Cisco 7507 router is now minimally conﬁgured

and ready to use. If you want to modify the

parameters after the initial conﬁguration, use the

setup command. To perform more complex

conﬁgurations, use the conﬁgure command. For

more information on additional interface

conﬁguration and information on more speciﬁc

system conﬁgurations, refer to the Cisco 7500 Series

Installation and Conﬁguration Guide.