Epson ActionScanner II Handmatig - Pagina 5
Blader online of download pdf Handmatig voor {categorie_naam} Epson ActionScanner II. Epson ActionScanner II 6 pagina's. Color scanner getting started for macintosh
Ook voor Epson ActionScanner II: Aan de slag (27 pagina's), Specificaties (6 pagina's), Aan de slag (22 pagina's)
Pagina afdrukken
Lights and Buttons
The scanner has three indicator lights and two buttons.
O PE RA TE b u t to n
R EA DY l i g h t
RE SE T b u t to n
light (green)
OPERATE
Comes on when the scanner is turned on.
light (green)
READY
Comes on when the scanner is ready to scan images. This light
flickers during scanning. When an error occurs, this light and
the
light indicate the type of error.
ERROR
light (red)
ERROR
Indicates when an error occurs. Along with the
indicates the type of error.
button
OPERATE
Turns the scanner on and off.
button
RESET
Resets the scanner after an error occurs. Pressing this button
during scanning stops the scanner and may cause an error in
the scanning software.
Scanner Errors
If an error occurs, the scanner stops operating and the
and
READY
ERROR
Error type
READY
Command error
On
Interface error
Off
Fatal error
Flashing
Command Error
The scanner has received incorrect commands from the
scanning software.
Scanners
E RR O R l ig h t
E RR O R l ig h t
O PE RA T E li g h t
READY
lights show the type of error.
ERROR
On
Flashing
Flashing
When this error occurs, try to rescan the document. The
scanner returns to normal when it receives correct commands.
Normally you do not need to reset the scanner.
Interface Error
The interface setup is wrong, or the scanner is not properly
connected to the computer.
When this error occurs, check the interface connection. Then
push the
RESET
on to reset it.
Fatal Error
This indicates one of the following problems:
One or more fluorescent lamps needs to be replaced.
The transportation screw has not been removed.
The scanner is broken.
Check that the transportation screw has been removed; then
push the
RESET
properly, try turning the scanner off, wait 10 seconds, and then
turn it back on. If the scanner still does not operate properly, or
if this error occurs repeatedly, consult your dealer.
light, it
Cleaning the Scanner
To keep the scanner operating at its best, clean it periodically.
Before cleaning, unplug the power cable.
Clean the outer case with mild detergent dissolved in water.
If the document glass gets dirty, clean it with a soft dry cloth. If
the glass is stained with grease or other hard-to-remove
material, use a small amount of glass cleaner on a soft cloth to
remove it. Wipe off any remaining liquid with a dry cloth.
Be sure there is no dust on the document glass. Dust can cause
white spots in the scanned image.
Caution:
Do not scratch or damage the document glass, and do not
use a hard or abrasive brush to clean it. A damaged glass
surface can decrease the scanning quality.
Never use alcohol, thinner, or corrosive solvent to clean the
scanner. These chemicals can damage the scanner components
as well as the case.
10/95
EPSON ACTIONSCANNER II
button or turn the scanner off and then back
button. If the scanner still does not operate
ActionScanner II-5