Cisco Nexus 7000 Series Handleiding vervangende instructies - Pagina 11

Blader online of download pdf Handleiding vervangende instructies voor {categorie_naam} Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 14 pagina's. Switch chassis
Ook voor Cisco Nexus 7000 Series: Referentiehandleiding (2 pagina's), Handleiding voor installatie-instructies (39 pagina's), Referentie (34 pagina's), Installatiehandleiding (18 pagina's), configureren (8 pagina's), Configuratiehandleiding (28 pagina's), Snelstarthandleiding (10 pagina's), Snelstarthandleiding (29 pagina's), Handleiding vervangende instructies (21 pagina's), Handleiding installeren (16 pagina's), Handleiding voor probleemoplossing (10 pagina's)

Removing the Blower

Cisco 7000 Air Filter and Chassis Blower Replacement Instructions 11

Purple (+24V)

Captive Allen-head screws

Figure 7

Chassis Blower

Remove the existing chassis blower as follows:

Step 1:

On each installed power supply, turn the power switch to OFF (O) and

unplug the power cord from AC source.

Step 2:

Remove the front panels according to the procedure in "Removing and

Replacing the Front Chassis Panels" on page 6.

Step 3:

Locate the blower (see Figure 1), which is mounted to the bottom of the

backplane, and the blower power connector (see Figure 8), which is

connected to the backplane under the white power bus bar. Note the

orientation of the power connector and its orientation in the backplane port,

with the ﬂat side down.

Blower power

connection

Black (ground)

Blower