Cisco SNS-3515 series Handmatig - Pagina 21

Blader online of download pdf Handmatig voor {categorie_naam} Cisco SNS-3515 series. Cisco SNS-3515 series 41 pagina's. Sns 3500 series
Ook voor Cisco SNS-3515 series: Hardware installatiehandleiding (41 pagina's), Handleiding voor probleemoplossing (8 pagina's)

Pagina afdrukken

Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances

Reverse the Cable Management Arm (Optional)

Step 1

Rotate the entire CMA assembly 180 degrees. The plastic cable guides must remain pointing upward.

Step 2

Flip the tabs at the end of each CMA arm so that they point toward the rear of the server.

Step 3

Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the

tab and pivot the tab 180 degrees so that it points toward the rear of the

Figure 9: Reverse the CMA

CMA tab on end of width-adjustment slider

Connect Cables

This section describes how to connect your Cisco SNS-3515 or Cisco SNS-3595 appliance to the network

and the appliance console.

•

Attach cables (such as keyboard, monitor cables, if required) to the rear of the server. Route the cables properly

and use the cable straps to secure the cables to the slide rails. See the

Back Panel View, on page 6

Connect the Network Interface, on page 22

Connect the Console, on page 23

Connect the Keyboard and Video Monitor, on page 24

Cable Management, on page 24

for reference on the rear view of the appliance.

Metal button for rotating

Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1

Connect Cables

Cisco SNS 3515 or SNS 3595 Appliance