Epson ES-300C Product ondersteunings bulletin - Pagina 4

Blader online of download pdf Product ondersteunings bulletin voor {categorie_naam} Epson ES-300C. Epson ES-300C 19 pagina's. Laser & non-impact printer error codes
Ook voor Epson ES-300C: Handmatig (8 pagina's), Aanvullende handleiding (15 pagina's), Handmatig (11 pagina's), Product ondersteunings bulletin (20 pagina's), Product ondersteunings bulletin (14 pagina's), Product ondersteunings bulletin (25 pagina's), Product ondersteunings bulletin (13 pagina's)

Epson ES-300C Product ondersteunings bulletin
15. Click on SAVE.
16. Close the SETTINGS notebook.
The next time a Win-OS/2 session is started, you will see the EPSON device driver
load. If you do not, repeat the above steps. If you have migrated a Windows
application to the OS/2 desktop, apply the above steps to that icon instead of the
Win-OS/2 icon. To verify that the configuration is correct, configure the DOS FULL
SCREEN icon using the same methods outlined in steps 6 through 16. Once you
have completed those steps, start a DOS FULL SCREEN session and run the
SCANTEST utility from the \WlNDOWS\TWAIN directory. If SCANTEST runs
successfully, chances are that the Windows session will run properly.
Epson TWAIN v2.xx
There is no special procedure required to setup this version of the driver to run in a
Windows session under OS/2 Warp. Simply launch Windows and install the driver.
Follow the procedures outlined in the user's manual. If the driver does not install
properly, verify that the device drivers mentioned earlier in this section are being
executed.
PSB No: P-0103A
Page: 4 of 4