Cisco UCS B460 M4 Installatie en onderhoud - Pagina 32

Blader online of download pdf Installatie en onderhoud voor {categorie_naam} Cisco UCS B460 M4. Cisco UCS B460 M4 46 pagina's. Blade server
Ook voor Cisco UCS B460 M4: Gegevensblad (7 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (5 pagina's), Installatie en onderhoud (50 pagina's)

Installing a New CPU and Heat Sink

Step 2

To ensure proper seating and prevent pin damage, place the CPU alignment tool with the registration marks

aligned, and press the green button on the tool to release the CPU in place.

Step 3

Close the socket latch.

Step 4

Secure the first hook, which has the following icon:

Step 5

Secure the second hook, which has the following icon:

Step 6

If reusing the heat sink, clean off the old thermal compound from the heat sink and CPU.

Step 7

Use the syringe of thermal grease to apply 2 cubic centimeters of the thermal grease (about half of the contents

of the syringe) to the top of the CPU where it will contact the heat sink. Use the pattern shown in the following

figure:

Figure 16: Thermal Grease Application Pattern

Note

Step 8

Replace the heat sinks and tighten the screws in the order shown in the following figure.

Figure 17: Tightening the Heat Sink Screws

Caution

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

CPUs come with two syringes of thermal grease; one with a blue cap and one with a red cap. Use

the syringe with the blue cap. This thermal grease has very specific properties. Thermal grease from

any other sources should not be used because it may lead to damage.

Left and right heat sinks are different and are not interchangeable. They must be installed in the

correct position.

Servicing the Blade Server