Cisco UCS Invicta C3124SA Installatiehandleiding - Pagina 29

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Cisco UCS Invicta C3124SA. Cisco UCS Invicta C3124SA 40 pagina's.
Ook voor Cisco UCS Invicta C3124SA: Upgradeprocedure (16 pagina's), Upgradeprocedure (20 pagina's)

Cisco UCS Invicta C3124SA Installatiehandleiding
Chapter 2
Installing the Cisco UCS Invicta C3124SA Appliance
Ethernet over SFP+ Twinax
Copper Cables (iSCSI only)
Ethernet over Ethernet over
10GBase-T (iSCSI only)
Cisco UCS Hardware and Software Interoperability Documents:
http://www.cisco.com/c/en/us/support/servers-unified-computing/unified-computing-system/products-t
echnical-reference-list.html
Cisco 10-Gigabit Ethernet Transceiver Modules Compatibility Matrix:
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/compatibility/matrix/O
L_6974.html.

Powering On

Use the following procedure to power on the Cisco UCS Invicta C3124SA Appliance:
Step 1
Attach a supplied power cord to each power supply in your Cisco UCS Invicta C3124SA Appliance, and
then attach the power cord to a grounded AC power outlet. See the
power specifications.
Wait for approximately two minutes to let the Cisco UCS Invicta C3124SA Appliance boot in standby
power during the first bootup.
You can verify power status by looking at the Power Status LED (see
Note
OL-31369-01
Off—There is no AC power present in the Cisco UCS Invicta C3124SA Appliance.
Amber—The Cisco UCS Invicta C3124SA Appliance is in standby power mode. Power is supplied
only to the CIMC and some motherboard functions.
Green—The Cisco UCS Invicta C3124SA Appliance is in main power mode. Power is supplied to
all Cisco UCS Invicta C3124SA Appliance components.
During bootup, the Cisco UCS Invicta C3124SA Appliance beeps once for each USB device that
is attached to the Cisco UCS Invicta C3124SA Appliance. Even if there are no external USB
devices attached, there is a short beep for each virtual USB device such as a virtual floppy drive,
CD/DVD drive, keyboard, or mouse. Connect a USB keyboard and VGA monitor by using the
supplied KVM cable connected to the KVM connector on the front panel (see
page
1-3).
Installing the Cisco UCS Invicta C3124SA Appliance In a Rack
N2XX-AIPCI01 dual-port 10Gb
SFP+ Ethernet adapter
Compatible cables:
SFP-H10GB-CU1M
SFP-H10GB-CU3M
SFP-H10GB-CU5M
UCSC-PCIE-ITG dual-port
10GBase-T Ethernet Adapter
Cisco UCS Invicta C3124SA Appliance Installation Guide
Compatible switch ports are
listed in the Cisco 10 Gb
Ethernet Transceiver Modules
Compatibility Matrix
Compatible cable:
CAT6A or better for 10G
Ethernet.
Physical Specifications, page A-1
Figure 1-3 on page
1-3):
Figure 1-3 on
for
2-9