Cisco 3600 Series Configuratiehandleiding - Pagina 24

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Cisco 3600 Series. Cisco 3600 Series 36 pagina's. Memory upgrade
Ook voor Cisco 3600 Series: Productoverzicht (10 pagina's), Upgrade-instructies (30 pagina's), Gebruikershandleiding (17 pagina's), Toepassingsnotitie (41 pagina's), Gebruikershandleiding (25 pagina's), Bijlage (15 pagina's), Gebruikershandleiding (7 pagina's), Handmatig (5 pagina's), Configuratie Opmerking (23 pagina's), Configuratie Opmerking (18 pagina's), Configuratie Opmerking (25 pagina's)

Pagina afdrukken
Cisco 3600 Series Configuratiehandleiding
Configure Voice over IP using a Trunk Connection
The routers on both sides of the Voice over IP connection must be configured for trunk connections.
For the scenario described in Figure 11, configure Router A to support trunk connections as follows:
configure terminal
voice-port 1/0/0
dial-peer voice 10 pots
dial-peer voice 100 voip
For the scenario described in Figure 11, configure Router B to support trunk connections as follows:
configure terminal
voice-port 1/0/0
dial-peer voice 20 pots
dial-peer voice 200 voip
To configure virtual trunk connections in Voice over IP, use the connection trunk command. The
following conditions must be met for Voice over IP to support virtual trunk connections:
•
Use the following voice port combinations:
— E&M to E&M (same type)
— FXS to FXO
— FXS to FXS (with no signaling)
•
Do not perform number expansion on the destination pattern telephone numbers configured for
trunk connection.
•
Configure both end routers for trunk connections.
•
The connected Cisco routers must be Cisco 2600 or Cisco 3600 series routers. The Cisco AS5300
does not currently support trunk connections.
Note
on each side of the trunk connection must match exactly.
VoIP establishes the trunk connection immediately after it is configured. Both ports on either end of
the connection are dedicated until you disable trunking for that connection. If for some reason the
link between the two switching systems goes down, the virtual trunk re-establishes itself after the
link comes back up.
VC-36
Voice, Video, and Home Applications Configuration Guide
connection trunk +15105554000
destination-pattern +13085551000
port 1/0/0
session-target ipv4:172.20.10.10
destination-pattern +15105554000
connection trunk +13085551000
destination-pattern +15105554000
port 1/0/0
session-target ipv4:172.19.10.10
destination-pattern +13085551000
Because virtual trunk connections do not support number expansion, the destination patterns