Cisco 3G MicroCell Gebruikershandleiding - Pagina 14
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco 3G MicroCell. Cisco 3G MicroCell 20 pagina's. At&t wireless network gps signal extender
Ook voor Cisco 3G MicroCell: Gebruikershandleiding (20 pagina's), Snelstarthandleiding (8 pagina's), Gebruikershandleiding (20 pagina's)
Pagina afdrukken
Troubleshooting
Your AT&T 3G MicroCell™ was designed to provide continuous service without intervention on your part. Occasionally, hardware
issues and Internet service interruptions can occur that disrupt the operation of the 3G MicroCell. We have provided the
following remedial troubleshooting steps so you can find the source of the problem and eliminate it, if possible.
Hardware Problems
Status
If...
Indicator
The 'Power' status indicator is red.
Power
The 'Ethernet' status indicator is off.
The 'Ethernet' status indicator is
Ethernet
flashing.
The 'Computer' status indicator is off.
Computer
The 'Computer' status indicator is
flashing green.
The 'GPS' status indicator is off.
GPS
The 'GPS' status indicator is still
flashing green after 60 minutes.
14
Then...
A hardware fault on the 3G MicroCell has occurred.
• Ifthe'Power'statusremainsred,yourdevicemayneedreplacement.
Return the device to place of purchase.
There is no physical connection to the 3G MicroCell Ethernet port.
• Confirmthatyourconfigurationiscorrectandthatallcablesare
firmly attached.
Cables are connected but no Internet access.
• Steadyflashingforlessthan3minutesisnormal.
• Ifflashingcontinuesformorethan3minutes,thisindicatesthat
there could be an error in your cable configuration. Confirm
configuration and recycle power (Off/On) on all devices according
to the sequence specified for your configuration option.
See Step 2: Configuration and Powering Up on page 8.
• NormalforthosewithOptionAconfiguration(noEthernet
connection to the 'Computer' port on the 3G MicroCell).
• ForthosewithOptionBorCconfigurations(acomputerorrouter
is connected by Ethernet cable to the 'Computer' port) check that
cables are firmly connected.
Your computer is passing data – this is normal during data transfer.
The 3G MicroCell does not have GPS lock.
• Itisnormalforthestatusindicatortobeoffinitiallywhenyoufirst
power up.
• Tryrecyclingpower(Off/On)onthe3GMicroCell.Iftheconditiondoesnot
clear, contact ATMC Customer Service at
for assistance.
The 3G MicroCell cannot acquire a GPS lock.
• IfyouwereneverabletogetaGPSlock(solidgreenstatus)–refer
to FAQ 1.3 on page 16.
• Ifatanytimeafteryouhaveactivatedtheunit,younoticethatthe
GPS status indicator is flashing green for 60 minutes or more – refer
to FAQ 1.3 on page 16.
• Recyclepower(Off/On)onalldevicesaccordingtothesequence
specified for your configuration option. See Step 2: Configuration
and Powering Up on page 8.
910-754-4311