Acuity Brands LITHONIA LIGHTING PRECISE ELA LRIS 120/277 ELN Series Handleiding voor installatie-instructies - Pagina 6
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Acuity Brands LITHONIA LIGHTING PRECISE ELA LRIS 120/277 ELN Series. Acuity Brands LITHONIA LIGHTING PRECISE ELA LRIS 120/277 ELN Series 6 pagina's. Recessed emergency edge lit led exit signs, recessed emergency rough-in sections
Pagina afdrukken
WIRING INSTRUCTIONS AND
DIAGRAMS
Cap all unused leads
separately
WIRING:
Select and remove desired knockout for AC power input and
ensure adequate lengths of AC power leads extending into
inside of cover can
.
Connect AC power supply according to proper wiring
diagram. Cap all unused leads with wire nuts. Use cup
washer
and green ground screw
22
grounding wire to the fixture (see Fig. 1).
MAINTENANCE:
LAMP REPLACEMENT:
1.
Remove recess mounting plate
assembly
from rough-in section by unscrewing two
captive mounting screws
2.
Disconnect lamp plug assembly
3.
Remove end cap screw
side of lamp housing).
4.
Slide lamp board assembly from lamp housing
5.
Replacement is reverse of above.
BATTERY REPLACEMENT:
1.
Remove recess mounting plate
from rough-in section by unscrewing two captive mount-
ing screws m. See figure 1.
2.
Disconnect lamp plug assembly
assembly
.
29
3.
Remove mounting bracket screw
ing bracket by sliding it slightly forward to release
opposite end.
4.
Disconnect battery connecter, and pry battery from
bracket using a flat blade screwdriver.
5.
Replacement is reverse of above.
Wiring Diagram
(provided) to connect
23
, and lamp housing
. See Fig. 1.
.
and end cap
(connector
.
, and lamp assembly
andf power plug
, and remove mount-
25
INVERTER/CHARGER BOARD
REPLACEMENT:
1.
Remove recess mounting plate
from rough-in section by unscrewing two captive mounting
screws m. See figure 1.
2.
Disconnect lamp plug assembly
3.
Remove mounting bracket screw
ing bracket by sliding it slightly forward to release
opposite end.
4.
Remove board by depressing locking wings of each
standoff white lifting board gently at standoff location.
5.
Cut strain relief wire tie holding wire bundle to bracket.
6.
Remove inverter/charger board with all attached wiring.
7.
Replacement is reverse of above.
TEL: 800-334-8694 Fax: 770-981-8141 www.lithonia.com
Page 6
, and lamp assembly
.
, and remove mount-
25
EMERGENCY LIGHTING SYSTEMS
Part Number EMCSA00575
REV. E