Cisco ASR 9000 Series Configuratiehandleiding - Pagina 32
Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Cisco ASR 9000 Series. Cisco ASR 9000 Series 50 pagina's. Line card
Ook voor Cisco ASR 9000 Series: Netwerkinstellingen configureren (26 pagina's), Configuratiehandleiding (46 pagina's), Handmatig (24 pagina's), configureren (46 pagina's), Handmatig (44 pagina's), Snelle referentiehandleiding (7 pagina's)
Pagina afdrukken
How to Configure Serial Interfaces
Command or Action
Step 3
pvc vpi/vci
Example:
RP/0/0RP0/CPU0:router(config-if)# pvc 5/20
Step 4
end
or
commit
Example:
RP/0/0RP0/CPU0:router(config-fr-vc)# end
or
RP/0/0RP0/CPU0:router(config-fr-vc)# commit
Step 5
Repeat Step 1 through Step 4 to bring up the serial
subinterface and any associated PVC at the other end
of the AC.
What to Do Next
•
•
•
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
530
To configure optional PVC parameters, see the
Parameters" section on page
For detailed information about configuring L2TPv3 in your network, see the "Implementing Layer
2 Tunnel Protocol Version 3" module of the Cisco IOS XR Virtual Private Network Configuration
Guide for the Cisco CRS Router. For detailed information about configuring L2VPNs, see the
"Implementing MPLS Layer 2 VPNs" module of the Cisco IOS XR Virtual Private Network
Configuration Guide for the Cisco CRS Router.
For detailed information about configuring L2TPv3 in your network, see the "Implementing Layer
2 Tunnel Protocol Version 3 on Cisco IOS XR Software" module of the Cisco IOS XR Virtual Private
Network Configuration Guide for the Cisco XR 12000 Series Router. For detailed information about
configuring L2VPNs, see the "Implementing MPLS Layer 2 VPNs on Cisco IOS XR Software"
module of the Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco XR 12000
Series Router.
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Purpose
Creates a serial permanent virtual circuit (PVC) and enters
serial Layer 2 transport PVC configuration mode.
Note
Only one PVC is allowed per subinterface.
Saves configuration changes.
When you issue the end command, the system prompts
•
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the
–
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
–
Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
Brings up the AC.
The configuration on both ends of the AC must
Note
match.
"Configuring Optional Serial Layer 2 PVC
531.
OL-26061-03