Cisco Physical Access CIAC-GW-K9 Installeren en configureren - Pagina 25

Blader online of download pdf Installeren en configureren voor {categorie_naam} Cisco Physical Access CIAC-GW-K9. Cisco Physical Access CIAC-GW-K9 26 pagina's. Physical access gateway
Ook voor Cisco Physical Access CIAC-GW-K9: Snelstarthandleiding (17 pagina's)

Cisco Physical Access CIAC-GW-K9 Installeren en configureren
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
Resetting the Cisco Physical Access Gateway
Reset the Gateway to powercycle the module, restore the factory settings, or delete the stored logs and
other data. The effect of the restart depends on the type of restart your perform, as described in the
following sections. You can reset the module using the physical button on the side of the module, or in
software using either the web administration tool or the Hardware device view in Cisco PAM.
Soft Reset (Powercycle)
Use the soft reset to powercycle the Cisco Physical Access Gateway. A soft reset reloads the device
firmware to clear any software issues, but does not impact stored data. The password, logs and other
information are retained.
Use one of the following methods to perform a soft reset:
Hard Reset (Restore Factory Defaults)
A hard reset deletes all information on the device (including log and event data) and resets the password
and all other configurations to the factory default. Any custom configurations previously entered on the
device are removed.
Note the following:
Use one of the following methods to perform a hard reset:
OL-32499-01
Soft Reset (Powercycle), page 2-25
Hard Reset (Restore Factory Defaults), page 2-25
Hardware reset button: Press and release the reset button once. See
location of the Reset button.
Gateway web administration tool: Follow the instructions in the
Gateway Using a Direct Connection" section on page 2-15
the Reset button at the bottom of the screen.
Cisco PAM desktop software: Open the Hardware module in the Doors menu and right-click on
a Gateway Controller (blue icon). Choose Reset from the menu.
Allow five to 10 minutes for the hard reset erase operation to complete.
Do not disconnect power from the module until the hard reset erase process is complete. Loss of
power during a hard reset can result in equipment malfunction.
The SVR LED flashes throughout the erase operation.
The module reboots with the existing firmware image after the hard reset is complete.
Hardware reset button: Press Reset button three times in succession. See
for the location of the Reset button.
Gateway web administration tool: Follow the instructions in the
Gateway Using a Direct Connection" section on page 2-15
the Restore Factory Defaults button at the bottom of the screen.
Resetting the Cisco Physical Access Gateway
Figure 2-2 on page 2-3
"Configuring and Managing the
to connect a PC to the Gateway, and click
Figure 2-2 on page 2-3
"Configuring and Managing the
to connect a PC to the Gateway, and click
Cisco Physical Access Gateway User Guide
for the
2-25