Cisco VG204XM Hardware installatiehandleiding - Pagina 39
Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Cisco VG204XM. Cisco VG204XM 48 pagina's. Voice gateways
Ook voor Cisco VG204XM: Snelstarthandleiding (19 pagina's)
Pagina afdrukken
Chapter 3
Installing the Voice Gateway
Procedure
Step 1
Connect the RJ-45 end of a DB-9–to–RJ-45 serial cable to the RJ-45 Console Aux port on the chassis.
Figure 3-7
Figure 3-7
1
Step 2
Connect the DB-9 end of the RJ-45–to–DB-9 serial cable to the to the COM port on your laptop or PC.
Note
To communicate with the voice gateway, begin a terminal emulator application.
Step 3
Connecting an FXS Line
Use a standard straight-through RJ-11 modular telephone cable to connect a Foreign Exchange Service
(FXS) port to a telephone or fax machine.
Warning
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call.
For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection: FXS.
OL-15959-01
shows the RJ-45 end of the serial cable connected to the Console Aux port on the chassis.
Connecting a Terminal or PC to the Console Port
VG 20 4
Fa stE the rne
t
CO NS OL E
FX S
0/1
0/0
AU X
0/3
0/2
0/1
1
RJ-45 connector to the Console Aux port on
the chassis
Some laptops and personal computers do not have DB-9 serial port connectors and may require
a USB to serial port adapter.
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide
0/0
12 V DC
SA
2
2
DB-9 connector
Connecting Cables
3-11