Epson ProofPlus TM-H6000III Ontwikkelingshandboek - Pagina 16

Blader online of download pdf Ontwikkelingshandboek voor {categorie_naam} Epson ProofPlus TM-H6000III. Epson ProofPlus TM-H6000III 45 pagina's. Ecc printer
Ook voor Epson ProofPlus TM-H6000III: Producthandleiding (27 pagina's), Brochure (2 pagina's), Specificaties (2 pagina's), Brochure (6 pagina's), Gebruikershandleiding (32 pagina's), Ontwikkelingshandboek (26 pagina's), Ontwikkelingshandboek (32 pagina's), Handmatig (10 pagina's), Gebruikershandleiding (29 pagina's)

3) CHK_DI_READ_AREA

Parameter

Command

pData

pString

Explanation

Specifies the reading area to set in pString.

Example:

When you use the area of X = 0, Y = 500, CX = 1000,

CY = 1500,

specify pString = "0, 500, 1000, 1500".

X is the X coordinate of the start of the specified area.

Y is the Y coordinate of the start of the specified area.

CX is the X coordinate of the end of the specified area.

CY is the Y coordinate of the end of the specified area.

The values specified here affect MapMode.

Use the null character string ("") to cancel the specified area.

If the range of specified area exceeds the available range of the device,

it is reduced to within the effective range.

When you specify the reading area, you must set the size of check in the

DocumentWidth and DocumentHeight properties before executing the

EndInsertion method.

Be sure to specify the X coordinate of the end of the specified area.

Scanning fails if the length from the specified coordinates to the left end

of the paper is less than 50 mm. In this case, ECHK_PTRERROR is

notified as ErrorEvent.

Use the CHK_DI_ENDINSERTION_EXTEND command to enable the

setting. Please refer to CHK_DI_ENDINSERTION_EXTEND for details.

The settings with this command are effective only for check scanner

mode. Although during card scanner mode, a reading area can be set

by executing this command, the settings are not reflected to card

reading directly. If these settings are set during card scanner mode,

the settings become effective after changing the mode to check scanner

mode, and only for reading checks.

APPLICATION DEVELOPMENT GUIDE

Explanation

CHK_DI_READ_AREA

Not used. "0" is always entered.

Character string to specify an area.

CheckScanner

Version 3.00 Feb. 2019