Epson Stylus CX4600 Snelle referentie - Pagina 30

Blader online of download pdf Snelle referentie voor {categorie_naam} Epson Stylus CX4600. Epson Stylus CX4600 48 pagina's. Epson scan icm updater v1.20 (psb.2008.07.001)
Ook voor Epson Stylus CX4600: Brochure & specificaties (2 pagina's), Productinformatieblad (4 pagina's), Beknopte handleiding (14 pagina's), Documentatie bijwerken (2 pagina's), Handleiding starten (8 pagina's), Installatiehandleiding (2 pagina's), Update (1 pagina's)

Cleaning the Print Head

If your printouts are unexpectedly light or faint, or you notice light or dark bands

across your printout, you may need to clean the print head. This unclogs the

nozzles so they can deliver ink properly. Run a nozzle check as described on

page 29 to see if the print head needs cleaning.

Note:

Print head cleaning uses ink, so clean it only if quality declines and the nozzle check

indicates that the print head needs to be cleaned.

If the red

ink light comes on or flashes, you cannot clean the print head. In this case,

replace the appropriate ink cartridge first. (See page 31.)

1. Make sure the CX4600 is on and the

2. Hold down the

The CX4600 runs a head cleaning cycle and the

Caution:

Never turn off the CX4600 while head cleaning is in progress. You may damage it.

3. When the

page 29) to verify that the print head is clean.

4. If there are still gaps or the test patterns are faint, run another cleaning cycle

and check the nozzles again.

Note:

If you don't see any improvement after cleaning the print head four or five times,

turn off the CX4600 and wait overnight. This lets any dried ink soften. Then try

cleaning the print head again. If quality still does not improve, one of the ink

cartridges may be old or damaged and needs to be replaced. See the next section.

Tip:

If you do not use your CX4600 often, it is a good idea to print a few pages at least once

a month to maintain good print quality.

Maintaining Your CX4600

ink button for 3 seconds until the

light stops flashing, run a nozzle check (as described on

ink light is off.

light flashes.

light starts flashing.