Epson LQ-570e Handleiding productinformatie - Pagina 13

Blader online of download pdf Handleiding productinformatie voor {categorie_naam} Epson LQ-570e. Epson LQ-570e 18 pagina's. Epson serial impact dot matrix printers
Ook voor Epson LQ-570e: Handleiding productinformatie (8 pagina's), Handmatig (12 pagina's), Snelle referentiehandleiding (15 pagina's), Specificaties (2 pagina's), Montagehandleiding (8 pagina's), Product ondersteunings bulletin (16 pagina's), Referentiehandleiding (34 pagina's)

5. Replace the paper tension unit by lowering it onto the

mounting pegs. Then press down both ends of the unit

until it clicks into place.

6. Replace the paper guide and the printer cover. Then close

the paper guide cover.

The top-of-form position is where the printer will start printing

on the page. If your printing appears too high or low, follow the

steps below to use the micro adjust feature to adjust the top-of-

form position.

1. Make sure the printer is turned on.

2. If necessary, load paper as described earlier. If you load

paper onto the push tractor, press the

advance the paper to the current top-of-form position.

3. Lift the printer cover up and off the printer.

4. Hold down the

button for about 3 seconds. The

Pause light starts flashing and the printer enters the micro

adjust mode.

5. Press the

up on the page, or press the

the top-of-form position down on the page.

To adjust the top-of-form position for continuous paper

loaded on the pull tractor, see the following example:

First mark a point 0.26 inch (6.5 mm) above the paper's

perforation; then position the paper so that the mark is even

with the top edge of the plastic ribbon cover. This gives you

a 0.33-inch (8.5-mm) margin on the next page, meaning

button to

the printer starts printing 0.33 inch (8.5 mm) below the

perforation. If you mark a point 0.22 inch (5.5 mm) above

the perforation, you get a 0.37-inch (9.5-mm) margin on

the next page.

6. After you set the top-of-form position, press the

button to exit micro adjust mode.

4/00

EPSON LQ-570e

D button to move the top-of-form position

U button to move

EPSON LQ-570e

- 13