Epson R1400 Montagehandleiding
Blader online of download pdf Montagehandleiding voor {categorie_naam} Epson R1400. Epson R1400 21 pagina's. Eco-flo continuous ink system
Pagina afdrukken
IMPORTANT
If your printer is new, set it up according to
the enclosed manufacturers instructions.
This is a check to ensure your new printer
and drivers are working correctly before the
Eco-Flo System is installed.
It is very important you read these instructions carefully before you begin!
We will take you through the following steps:
1
Preparing your Injector
2
Setting up of the Inks in the bottle tray
3
Installation of the modified injector to your printer
4
Fitting of the Tube Supports System
5
Producing your first print.
Only start work on the installation once you have read the
What you will need to Install the Eco-Flo R1400
*
Complete Eco-Flo R1400 Kit
*
Sharp Blade (Stanley Knife type) & Scissors
*
Measuring Tape or Ruler
*
Marking Pen or Pencil
*
Paper Towels
Please read carefully before you continue and
refer to the components diagram over the
page
ECO-FLO CONTINUOUS INK SYSTEM
Ink System
EPSON PRINTER
instructions fully!
Assembly Instructions for
Epson R1400 Eco-Flo Shown
What is included in your Eco-Flo R1400 Kit
*
Injector Set with tubes attached
*
Set 6 Inks & empty 100ml bottles
*
6 Bottle Caps & clear piping tubes
*
Tube Support Bracket with Self Adhesive
Pads fitted
*
Bottle Holder Tray
*
Special Injector Lid & 2 Chip Blocks
*
1x Grey/White Tube Clip with adhesive pad
*
Installation Instructions and Profiles CD
*
10ml Syringe & wing adaptor
*
Pair of latex gloves
*
6 Tube Clamps
*
Foam Strip
1
PermaJet
R1400
:
Epson R1400
Part No. APJ29421