Epson Stylus Color 880 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Epson Stylus Color 880. Epson Stylus Color 880 13 pagina's. Product support bulletin(s)
Ook voor Epson Stylus Color 880: Specificatieblad (2 pagina's), Product ondersteunings bulletin (6 pagina's), Product ondersteunings bulletin (1 pagina's), Productinformatieblad (4 pagina's), Specificatie (2 pagina's), Start Here (4 pagina's), Product ondersteunings bulletin (3 pagina's), Product ondersteunings bulletin (2 pagina's), Product ondersteunings bulletin (4 pagina's), Product ondersteunings bulletin (7 pagina's), Installatiehandleiding (17 pagina's), Snelstarthandleiding (2 pagina's)

Pagina afdrukken

Epson Stylus Color 880 Gebruikershandleiding

1. Testing the Printer

3. Lift up the two ink cartridge clamps.

4. Unwrap the ink cartridges, then remove only the yellow

part of the tape seal on the top.

black cartridge

5. Tilt each cartridge forward slightly as you lower it into its

holder. Hang the tabs at the back of the cartridge on the

hooks.

Don't place the cartridges under

the hooks; you may damage the

clamp when you close it.

6. Press down on the ink cartridge clamps until they lock in

place, but don't press down on the cartridges themseleves.

7. Press the A cleaning button and close the printer cover.

Ink charging takes about one and a half minutes, with the

P power light flashing and the printer making noise until it's

finished.

color cartridge

Don't turn off the printer or interrupt charging or it will start

over, using more ink than necessary. It's finished when the

P power light stops flashing.

Testing the Printer

You can run a printer check to determine whether a problem

comes from the printer itself or some other source. Follow

these steps to run the printer check:

1. Make sure both the printer and computer are turned off.

2. Disconnect the interface cable from the printer.

3. Make sure paper is loaded in the printer.

4. Hold down the S load/eject button, then press and release

the Ppower button. Continue holding down the

S load/eject button until the Ppower light starts to flash,

then release it.

The printer prints one page showing its ROM version

number, ink counter, and a nozzle check pattern. Only the

nozzle check pattern is shown below. (If the pattern has

gaps in its dots, you need to clean the print head; see

page 9.)

5. To end the check, turn off the printer after it prints the

check page. Then reconnect the interface cable and turn on

your printer and computer.

If the check page prints, the problem probably lies in your

software settings, the interface cable, or your computer.

If the check page doesn't print, you may have a problem with

your printer.

Try the suggestions in "Problems and Solutions" in the Printer

Basics book.

8/00

EPSON Stylus Color 880/880i

- 5