Dillon ED-2000plus Gebruikershandleiding - Pagina 16
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dillon ED-2000plus. Dillon ED-2000plus 20 pagina's. Electronic dynamometer with hr-2000 remote
Pagina afdrukkenThe Destination address must
match with the address entered
in the ED-2000plus. This value
has a default of 100.
Entering a destination address
of 0 will cause the remote to
send a signal called a "Broad-
cast signal". The first
ED-2000plus that responds with
its value will then be locked in.
16
To assign the correct address for each part of the system, you must access
the address mode. Follow these steps to access and set the proper ad-
dress.
1. With one hand, press and hold
the F key and use the other hand
to press the ON/OFF key. . .
2. Increment or decrement the
address number using the keys
described in Table 6 until the
address you want is on the
screen.
3. Press the UNITS key to save the
change and move to the next
item in the address mode. . .
4. Increment or decrement the
address number using the keys
described in Table 6 until the
address you want is on the
screen.
5. Press the UNITS key to save the
change and move to the next
item in the address mode. . .
6. Increment or decrement the
address number using the keys
described in Table 6 until the
address you want is on the
screen.
SEtuP is displayed then 100. This is
the Destination address currently
assigned to the ED-2000plus.
Remember to follow the recommen-
dations in Table 7.
SourcE is displayed while the UNITS
key is held then the Source address
is displayed when the key is re-
leased. This is the address currently
assigned to the HR-2000.
Remember to follow the recommen-
dations in Table 7.
POLL is displayed while the UNITS
key is held then the poll value is
displayed when the key is released.
This value identifies the number of
remotes that may be operating in a
given airspace. This value has a
default of one. Changing the value will
have the effect of increasing the time
between display updates.